RC100 (5V) Noiseless Resistor Cable Discontinued | |
| More variations available Show | |
Zalman RC100 (5V) Noiseless Resistor Cable
This small resistor converts 3-pin fans from 12 volts to approximately 5 volts. This basically means it reduces the speed of your 3-pin fans, which in turn reduces the noise the fan makes. We tested the resistor with a 92mm fan and without the resistor installed the fan ran at 2700 RPM. Once the resistor was installed the fan ran around 1100 RPM. The reduction in noise was significant.
Installation considerations
Fitting the resistor is very straightforward. Just plug the 3-pin fan into one end of the resistor and then the other end connects directly to your motherboard.
NOTE: The resistor reduces the RPM of the fan, in turn this reduces the air flow that the fan produces. Please bear that in mind when purchasing this resistor.
See Also
Top Cables and adapters
Quiet PC IEC C13 UK Mains Power Cord, 1m (Type G)
Gelid PWM Adaptor Cable for VGA Cooler Fans
Gelid PWM Y Cable, Connect two PWM fans to one socket
Quiet PC Cloverleaf C5 UK Mains Power Cord, 1.8m (Type G)
Quiet PC IEC C13 Euro Mains Power Cord, 2m (Type F)
Gelid 3-pin Fan Resistor Cable
Streacom RZ4 PCIe Gen4 Riser Cable
Gelid 1-to-4 RGB Splitter Cable
Noctua NA-SEC1 4-Pin PWM Fan Extension Cables, 3 pack
Quiet PC Cloverleaf C5 Euro Mains Power Cord, 0.6m (Type F)
